EFR32 Mighty Gecko 13 Software Documentation
efr32mg13-doc-5.1.2
|
Driver for the Cambridge CMOS Sensors CCS811 gas and indoor air quality sensor.
Copyright 2016 Silicon Laboratories, Inc. http://www.silabs.com
This file is licensed under the Silicon Labs License Agreement. See the file "Silabs_License_Agreement.txt" for details. Before using this software for any purpose, you must agree to the terms of that agreement.
Definition in file ccs811.c.
#include <stddef.h>
#include <stdio.h>
#include <string.h>
#include <stdarg.h>
#include "i2cspm.h"
#include "thunderboard/board.h"
#include "thunderboard/ccs811.h"
#include "thunderboard/util.h"
#include "thunderboard/rfs/rfs.h"
Go to the source code of this file.
Functions | |
uint32_t | CCS811_deInit (void) |
De-initializes the chip. More... | |
void | CCS811_dumpRegisters (void) |
Dumps the registers of the CSS811. More... | |
uint32_t | CCS811_getHardwareID (uint8_t *hardwareID) |
Reads Hardware ID from the CSS811 sensor. More... | |
uint32_t | CCS811_getMeasurement (uint16_t *eco2, uint16_t *tvoc) |
Reads measurement data (eCO2 and TVOC) from the CSS811 sensor. More... | |
uint32_t | CCS811_getRawData (uint16_t *current, uint16_t *rawData) |
Gets the latest readings from the sense resistor of the CSS811 sensor. More... | |
uint32_t | CCS811_getStatus (uint8_t *status) |
Reads the status of the CSS811 sensor. More... | |
uint32_t | CCS811_init (void) |
Initializes the chip and performs firmware upgrade if required. More... | |
bool | CCS811_isDataAvailable (void) |
Checks if new measurement data available. More... | |
uint32_t | CCS811_readMailbox (uint8_t id, uint8_t length, uint8_t *data) |
Reads data from a specific Mailbox address. More... | |
uint32_t | CCS811_setEnvData (int32_t tempData, uint32_t rhData) |
Writes temperature and humidity values to the environmental data regs. More... | |
uint32_t | CCS811_setMeasureMode (uint8_t measMode) |
Sets the measurement mode of the CSS811 sensor. More... | |
uint32_t | CCS811_softwareReset (void) |
Performs software reset on the CCS811. More... | |
uint32_t | CCS811_startApplication (void) |
Switches the CSS811 chip from boot to application mode. More... | |