Configure Transfers. More...

Configure Transfers.

The DAP_TransferConfigure Command sets parameters for DAP_Transfer and DAP_TransferBlock.

DAP_TransferConfigure Command:

  BYTE | BYTE ******** SHORT *****| SHORT ******|
> 0x04 | Idle Cycles | WAIT Retry | Match Retry |
 ******|*************|************|*************|

Idle Cycles: Number of extra idle cycles after each transfer.
WAIT Retry: Number of transfer retries after WAIT response.
Match Retry: Number of retries on reads with Value Match in DAP_Transfer. On value mismatch the Register is read again until its value matches or the Match Retry count exceeds.

retry = Match_Retry;

do {

if ((Register_Value & Match_Mask) == Match_Value) break;

} while (retry--);

DAP_TransferConfigure Response:

  BYTE | BYTE **|
< 0x04 | Status |
 ******|********|