Control and monitor SWD/JTAG Pins. More...

Control and monitor SWD/JTAG Pins.

The DAP_SWJ_Pins Command is used to monitor and control the I/O Pins including the nRESET Device reset line.

The Pin Wait time is useful in systems where the nRESET pin is implemented as open-drain output. After nRESET is de-asserted by the debugger, external circuit may still hold the target Device under reset for a time. Using the Pin Wait time, the debugger may monitor selected I/O Pins and wait until they the expected value appears or a timeout expires.

I/O Pin Mapping for the fields Pin Output, Pin Select, and Pin Input:

Bit 0: SWCLK/TCK
Bit 1: SWDIO/TMS
Bit 2: TDI
Bit 3: TDO
Bit 5: nTRST
Bit 7: nRESET

DAP_SWJ_Pins Command:

  BYTE | BYTE ******| BYTE ******| Word ****|
> 0x10 | Pin Output | Pin Select | Pin Wait |
 ******|************|************|**********|

Pin Output: Value for selected output pins
Pin Select: Selects which output pins will be modified
Pin Wait: Wait timeout for the selected output to stabilize
- 0 = no wait
- 1 .. 3000000 = time in µs (max 3s)

DAP_SWJ_Pins Response:

  BYTE | BYTE *****|
< 0x10 | Pin Input |
 ******|***********|

Pin Input: Pin state read from target Device.